There are two camps I’ve run into regarding cracked heat exchanger diagnosis. Those who look for it everywhere and those who dismiss it and never look.
I will start by saying that everything I write here is my own opinion and experience. Because this is such a hot button topic don’t take my word for any of this, follow manufacturer, industry standards and codes and obviously stop reading unless you are a trained and licensed professional.
Heat exchanger cracks are worth finding but they aren’t the most dangerous issue for your customers in most cases
The reason I make this blasphemous statement is twofold.
- Many heat exchangers are at a negative pressure in reference to the air moving over the exchanger. This means that the air from the return will move into the exchanger rather than combustion gasses moving into the airstream.
- So long as the combustion process is complete there won’t be significant CO ( Carbon Monoxide) in the flue,
But let’s be clear… If there are any cracks in an exchanger it needs to be replaced, there should NOT be cracks in a heat exchanger. The trouble comes in when we think that looking for cracks in the only or even primary method of finding CO issues with a furnace.
When we rely on our eyes to find every issue we can easily miss problems (including cracks) that our eyes can’t see. So here are my suggestions on how to find cracked heat exchangers and other furnace safety issues.
Ambient Carbon Monoxide
One of the first things you should do is measure ambient CO in the conditioned space while the heat is running with either a combustion analysis tool or a personal CO detection device. Anything other than ZERO ambient carbon monoxide is worth investigating. Sure, smoking indoors or cooking can increase ambient CO above zero but when you see it take the time to INVESTIGATE.
One of the oldest ways to check for heat exchanger cracks is to simply observe the flame when the blower starts. Most furnaces will have a blower delay to get the furnace up to temperature before moving air over the exchanger. This procedure is as simple as watching the flame and observing if it the flame moves or changes when the blower starts.
Because the burner and heat exchanger is isolated from the airstream there should be no change in the flame when the blower starts. If there is you need to begin looking for connection or leakage between the burner/heat exchanger and the air.
Testing combustion won’t necessarily tell you if you have an exchanger leak but it will tell you if you have a high CO which can help you prevent a dangerous situation for your customers if there is an exchanger crack.
Exchanger Isolation Pressure Test
When you suspect the system may have an exchanger leak you can place a manometer probe in the exchanger and seal off the inlet/outlet of the exchanger as best you can (with the gas shut off obviously). Next, turn on the blower and see if there is a change in the exchanger. Any change is an indication of a heat exchanger leak.
In some cases, an old-fashioned visual inspection makes the most sense, either by removing the blower or the high limit (or both) and using a mirror or borescope to inspect. When you do find a cracked exchanger it should be quoted for repair and the furnace turned off.
While finding cracked exchangers is worthwhile I would place it below or on par with other things like –
- Testing for spillage due to depressurization in the combustion air zone
- Insufficient Combustion Air
- Blocked intake and/or exhaust
- Recirculation of combustion products into intake vents or soffits
- Gas pressure testing / clocking the meter for overfiring or underfiring
- Testing heating airflow
- Testing for CO in the occupied space
- Visual inspection of vents, flues, and chimneys for proper installation as well as gaps and cracks
- Visual inspection for return gaps pulling in air around the furnace
When you do find exchanger cracks on newer units you need to also looks for causes like low airflow, incorrect orifice size or overfiring that could have caused the issue.
Keep your eyes open and don’t get fixated on a single issue to keep your customers safe. While you are at it read this great combustion guide from Accutools and Jim Bergmann.