BACK

Ecobee Dehumidification Not Working? Check These Settings

Ecobee wired and the install looks clean, but the blower still won’t slow down to pull moisture out? On two-stage systems, dehumidification is the setup step techs miss most often. In this video, the team walks through the Ecobee settings that make dehumidify-on-demand work, and the field checks that confirm it before you leave the job.
youtube placeholder image

The “dehumidifier” here isn’t a standalone unit. The Ecobee controls the equipment’s DH input through a one-wire accessory on ACC+. When the relay opens and drops 24V, the indoor fan slows down, which gives you a colder coil and more moisture removal. If the relay is set wrong or the feature is never turned on, the system runs at full airflow and the humidity stays high.

Install and Equipment Setup

  • Accessory: select the one-wire option on ACC+
  • Relay: normally open (open = no power = reduced fan speed)
  • Dehumidify with fan: No
  • Minimum runtime delta: change it from the factory 5% to 2%
  • Dehumidify in heat mode: No, because the system itself is doing the dehumidification
  • Relay state: confirm it reads open, and correct it here if it says closed

 

Still Not Working? It’s Off by Default

Even after you set it up as an accessory, Ecobee dehumidification defaults to off. Go to the main menu, then the gear icon and system/equipment settings. Turn the dehumidifier on and set your target. We use 56% RH because 54% was hard to hit reliably.

Check It in Test Mode

Use test mode to call first and second stage cooling. Keep 24V on DH while you set the charge so you have full airflow. Then toggle dehumidification on and off and check that the fan speed drops and ramps back up. You’ll be able to hear the change.

Set Expectations with the Customer

Overcooling to dehumidify can run the house a couple of degrees below setpoint. Explain that up front so you don’t get a “too cold” callback. And plug in the remote sensors.

Comments

Most popular videos

view all

To continue you need to agree to our terms.

The HVAC School site, podcast, and tech tips are
made possible by generous support from