Refrigeration Circuit, Charging & Diagnosis

In HVAC/R, we are in the business of moving BTUs of heat, and we move BTUs via pounds of refrigerant. The more pounds we move, the more BTUs we move. In a single-stage HVAC/R compressor, the compression chamber maintains the same volume no matter the compression ratio. The thing that changes is the number of […]

Receivers, which we sometimes call “liquid receivers,” are components that store refrigerant. You’ll see it on everything from small self-contained refrigeration units to very large commercial and industrial systems. Many new techs who are used to residential air conditioning confuse receivers with accumulators. It’s an understandable mistake; they both contain liquid refrigerant. The main difference […]

Does setting a thermostat too low cause an air conditioning system set in cool mode to freeze? The answer is no, at least not directly. However, low evaporator load (low return temperature or low airflow) and low outdoor ambient temperature can lead to evaporator coil freezing. Low indoor setpoint can lead to low return air […]

There are many appliances with compression refrigeration circuits that do not have ports installed for testing, recovery, charging, and evacuation.  These can include window units, PTACs, fountains, refrigerators, and much more. This fact presents a challenge any time you suspect or know there is a refrigerant circuit issue. How can you diagnose and repair when […]

When we say that there is “flash gas” at a particular point in the system, it can either be a bad thing or a good thing, depending on where it is occurring. Flash gas is just another term for boiling. It is perfectly normal (and required) that refrigerant “flashes” or begins boiling directly after the […]

I was fresh out of school, working as an apprentice at my first real HVAC job, and I was listening in on a shop conversation between a few techs. They were talking about finding so many overcharged systems. One of the techs turns to me and says, “I had a unit yesterday that was so […]

I live in Central Florida, and while it can get pretty hot in the summer, we also tend to get afternoon thunderstorms that come and go in a flash. I have been connecting gauges, checking charges, and even pulling vacuums in the rain (even under umbrellas or cardboard boxes) for most of my career. Only […]

‘Tis heating season once again. It’s getting colder outside, and the heat pumps are starting to frost up outdoors. The defrost cycle helps get rid of the frost, and there are a few different ways we can do that; the methods themselves may differ between systems (time & temperature vs. demand defrost), as may the […]

Diagram above by Carrier  It’s really easy to put a liquid line drier in the proper location, but it’s still more commonly installed in the WRONG location. Namely, people install it right at the condensing unit. (OK, it isn’t that big of a deal, but I needed some dramatic emphasis.) Installing it at the indoor […]