Refrigeration Circuit, Charging & Diagnosis

Microchannel is a coil type used in many evaporator and condenser coils. You can easily identify it by its flat tubes, and its fins look like waves between the tubes. The technology was developed for use in the automotive industry and is used for radiators and automotive A/C condenser coils. These coils are made of […]

Photo by Ulises Palacios Refrigerant circuit restrictions can be common things like a plugged filter drier or a restricted metering device. They can also be more difficult to diagnose and stem from exotic issues like a kinked liquid line, blocked evaporator feeder tube, or a compressor connected improperly with a discharge line full of solder […]

First off, if you’ve never heard the term “beer can cold,” you are either not in the trade, or you have been living a pretty sheltered existence. I started as a tech apprentice when I was 17 years old, and on my first day in the truck, my trainer grabbed the suction line of a […]

In air conditioning service, we don’t always see systems with accumulators. In fact, they are pretty uncommon unless you work on a lot of heat pumps. However, as heat pumps gain popularity, charging systems with accumulators will be a good skill to have in your tool bag. We are Carrier dealers in Florida, so we […]

As we have mentioned in several previous articles (such as this one HERE), many blended refrigerants have glide, which simply means they boil and condense over a range of temperatures instead of just one temperature. As an example, consider refrigerant R407c. It is a zeotropic blend, which means it has enough glide to make a […]

Yeah? Well, how do you know? What should they be? What are the outdoor and return air temperatures? What SEER rating is the equipment?  These are the questions I ask every single time a technician says the phrase,  “But the pressures look good for [insert refrigerant of choice here].”  When they can’t answer the questions […]

We have discussed DTD (design temperature difference) quite a bit for air conditioning applications, but what about refrigeration? Let’s start by defining our terms again. Suction Saturation Temperature The saturation temperature is the temperature at which the refrigerant will be at a given pressure if it is currently changing state. This change of state would […]

If you work in refrigeration, you may have heard the term “hot pull down.” This phrase describes a condition where the load on the evaporator is above design due to the box temperature or the temperature of the product in the box being higher than it would normally be. My grandpa called me a few […]

This article was written by RSES CM and excellent market refrigeration tech Jeremy Smith. Thanks, Jeremy! I frequently see techs online struggling with charging or troubleshooting refrigeration equipment and using subcooling as a diagnostic or charging method. Please don’t do this unless you understand it fully. Many times, trying to charge a refrigeration system to […]