2019

In this two part interview Moe Hirsch goes deep an wide on buffer tanks and strategies for “parking” btus in hydronic systems

  Illustration Courtesy of Emerson CO2 is a pretty nice refrigerant. It has zero ODP (ozone depletion potential) and a GWP (global warming potential) of 1. CO2  has been used as a refrigerant almost from the very beginning of refrigerants, and it's been making a big comeback in market refrigeration (especially in colder climates). CO2 […]

This tip was written by HVAC Applications and Technical Specialist Dakota Brown. Thanks, Dakota! As a technician, it was always the same old story: Are you done yet? There was always pressure from the office—either from the dispatcher, service manager, or project manager—to get the job done and get it done quickly. When I became […]

This tip comes from market refrigeration and controls technician Kevin Compass. Thanks, Kevin! A little tip when changing liquid cores: If you start pumping them down, begin bypassing discharge gas into the shell to warm it up, push out the remaining liquid, and bring the shell above the dew point so that it doesn't sweat […]

Kevin Mayer from NAVAC comes talks about recovery and ways to make it work better and more safely for you.

Before the fighting starts about term definitions, let's just settle on using “adjustable drive pulley” and “sheave” interchangeably to describe the belt-driven power transmission device shown above. Second, for the newer tech, you shouldn't be altering these sheaves so that the belt rides lower or higher in them unless you know EXACTLY what you are […]

Grounding is an area of many myths and legends in both the electrical and HVAC fields. This is a short article, and we will briefly cover only a few common myths. For a more detailed explanation, I advise subscribing to Mike Holt's YouTube Channel HERE. Myth – Current Goes to Ground Actually, current (electrons) will […]