Tech Tips

Here is part 2 from Michael Housh from Housh Home Energy in Ohio. Thanks, Michael! This is part two in a series on a deeper look into the sensible heat rate equations. You can find the first article here HERE if you missed it. This article will dive deeper into the density of “standard air” […]

One of the most common questions we get from techs is about using a voltmeter to diagnose a high voltage circuit. It's especially tricky when a tech is used to working on a low-voltage or 120V circuit, where there is a clear “hot” side of the circuit and a clear “grounded” side of the circuit. […]

We had a situation a few months back where we needed to monitor amperage on a grocery store panel over a period of time. The trouble was that we needed data-logging capability AND accurate measurement at 600+ amps. Finding an all-in-one solution proved to be quite expensive. Luckily, my friend Jim Bergmann happens to own […]

Note: My brother Nathan wrote this a few years back, and I only did some minor editing. A pool heat pump is essentially a water-cooled air conditioner in reverse. It usually has a large air evaporator on the outside that looks like a condenser coil and a heat exchanger (usually tube-in-tube) on the inside. A […]

This article was written by Senior Refrigeration Tech Jeremy Smith. Before we get to it, I want to remind you that ALL of the tech tips are available in chronological order HERE, and you can sort through them alphabetically by selecting the letters and numbers above the tips. It's a great link to share with […]

Here is another great explanation from Michael Housh of Housh Home Energy in Ohio. Thanks, Michael! I’m going to lay out and compare the sensible heat rate equations for both the air-side and water-side of HVAC to help draw similarities and dive deeper into the science behind these equations. This is the beginning of a […]

This tip was written by a 19-year service tech, Frank Mashione. Thanks, Frank. Here is a tech tip from the field that had stumped me. Luckily for me, I knew the right person to call to get back on track. This business has complained about heat calls for quite a while. I have heard other […]

Michael Housh from Housh Home Energy in Ohio wrote this tip to help techs determine the air-side charge on a pressure tank. Thanks, Michael! Determining the air-side charge of an expansion tank in a hydronic heating system is a relatively easy task.  A properly sized and charged tank is designed to keep the system pressure […]

This tip was a COMMENT on the sensible heat ratio tip left by Jim Bergmann. As usual, Jim makes a great point; once you get the “sensible” capacity for a piece of equipment at a set of conditions, you can easily calculate a true target delta T. Another interesting thing you can do is use […]